|
DG Synchronizing Panel :-
We
offering DG Synchronizing Panel which is based on load in KW. Hence the
actual sharing, starting, stopping & transfers are actual load
dependent & not on any other unrealistic parameter like voltage,
current. etc. Changing of scheme becomes very easy because of changes
are made through software only. There is no changing of wires, adding
of components like relays, contactors, which is very time consuming,
cumbersome & requiring additional space.
Along with KW
sharing, KVAr sharing & PF sharing is very accurate, because of
PLC programming. There is no possibility of any unequal sharing as
regards KW, KVAr & PF. For any type of load addition or reduction,
manual intervention as regards D.G.set operation is not required.
However, in case of emergency manual override is possible. Special
programmers using Real Time Clock (RTC) are possible. With this
facility, along with KW dependent programs; day, date & time
dependent programmers are possible. Because of KW dependent load
sharing, optimum utilization of D.G. sets are possible. This increases
D.G. sets efficiency & saves lot of fuel.
D. G.sets are
always tried to run with 80 % to 90 % load factor, where we get maximum
efficiency of D.G.sets. This is easily possible with our system.
Because of PLC operation, hardware like relays, contactors, wiring etc
is reduced drastically. This reduces fault points & increases the
MTBF of the system.
|
